• Inicio
• obd 2
• Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

4.5 (125) · € 8.50 · En stock

The OBD-II UART Adapter for Arduino works as a data bridge between vehicle's OBD-II port and the serial UART of Arduino, used for reading out data such as speed or engine RPM from car's ECU computer. With dedicated Arduino library, it is extremely simple to perform a readout on Arduino. The adapter embeds a MPU-6050 accelerometer/gyro/temperature sensor module inside with I2C interface. The accelerometer can be used for measuring a car's acceleration and steering G-force. The gyroscope can be us

OBD-II TTL Adapter

motors interferencing I2C communication with MPU-6050 - Sensors - Arduino Forum

OBD-II / CAN Interface, obd

Freematics OBD-II UART Adapter V2.1 (for Arduino)

MPU6050 problem - Sensors - Arduino Forum

Connect 2 or more MPU6050 on board arduino Uno R3 - Project Guidance - Arduino Forum

Freematics Vehicle Data Logger V3 - DFRobot

How to get the best out of this forum - IDE 1.x - Arduino Forum

Arduino UNO with 2 Acclerometers (MPU6050) - Programming Questions - Arduino Forum