4.6 (259) · ⏠4.00 · En stock
## Usage 1. Print 1. Put unfolded paperclip / wire in (solder works great too!) 1. Put Switch into RCM by sliding on right side and holding VOL+ and pressing Power ## Debugging This might not be the greatest design of these as this is only v6 I printed and tested, but it does work. The paperclip I used wasn't cut down, but I did use a lighter to burn off any coating (if there was any, idk). The final paperclip had a resistance of 300-1000 Ohm, total length of ~8cm. ## Design decisions 1. Asymmetric: worked best in tests. 1. Longer: my own preference for jigs, to not lose them. Also makes using actual paperclips easier as you don't have to cut them short. 1. Thicker wire: up to 1.2mm wire should work, all my paperclips were 1mm+ so I needed a larger design 1. Simple top: there's a lot of space for designs on the top, but let's appreciate the clean look.
RCM Jig and wire bending template for Nintendo Switch by Sulya, Download free STL model
3D Printed Sheikah Slate Nintendo Switch Cover (with Stand) : 6 Steps (with Pictures) - Instructables
paperclip rcm jig 3D Models to Print - yeggi - page 9
Question Block Switch Cartridge Case. STL File for 3D Printing Digital Download.
STL file RCM Jig Switch HACK đČă»3D printing idea to downloadă»Cults
3D Printed Jig Issue - The Independent Video Game Community
â· 3d print nintendo switch jig ă STLFinder ă
Thingiverse - Digital Designs for Physical Objects
paperclip rcm jig 3D Models to Print - yeggi - page 7